Measurement approach
Keep position, direction and evaluation settings consistent when comparing turned or ground surfaces. Review method differences before attributing conflicting readings to instruments or machining.
Application planning note, not a customer test report. No measured customer results or performance guarantees are presented.
Plan and validate the workflow
- Identify the drawing revision, critical features, tolerances and datum scheme.
- Check workholding, probe access, surface response and environmental conditions on representative parts.
- Confirm the accessories, software and evaluation method before recording results.
- Retain original data and report unmeasured regions, processing choices and method limitations.
Related instruments
These are complementary candidates, not a requirement to buy every instrument. Confirm the role and suitability of each configuration with representative samples.
Selection boundaries
Resolution is not equivalent to measurement accuracy. Different evaluation methods are not automatically interchangeable. Reference standards, environment and the adopted decision rule must be considered when reporting results near an acceptance limit.
Manufacturer references
Instrument principles and intended uses are referenced below. The combined workflow is editorial guidance by Kemirui, not a manufacturer-validated customer test. Reviewed on 15 October 2026.
Plan a measurement for your sample
Share your material, sample dimensions, preparation and measurement objective. These details help identify the appropriate method and configuration.
